Operation 5
Error messages
6210_608-001
REFERENZHUB
REFERENCE LIFT message
NOTE
If you have shut down the control unit and
lower the load with the lift-lower operating
lever, the following happens when you restart:
You switch on the key switch. In the display,
the message
REFERENCE CYCLE (special
equipment) or no display appears. The forklift
truck will now only drive at a reduced speed.
You now have to perform a test lift (reference
cycle) using the lifting system:
– Lift the forks up until the message disap-
pears or, if it was not previously displayed,
until it appears and then disappears again.
– Then lower the forks again.
The truck can now be driven again with no
speed limitation.
7071_003-050
FAHRGEBER
FAHRGEBER (ACCEL. SENSOR)
message
If the FAHRGEBER (ACCEL. SENSOR)
message appears on the indicator and oper-
ating unit, the truck will remain stationary. The
accelerator must be checked.
– Contact your service office.
171673 [EN] 149
To Next Page
Loading...
Need help?
General
