DOC-34014 Rev. C 6–5
Objet24 User Guide
Tips about loading and replacing material cartridges:
¾ It recommended that you always have two material cartridges loaded in
the printer. When the weight of the material in one cartridge drops below
100 grams, the printer pumps material from both cartridges until one is
empty. If only one cartridge is used, printing stops when the weight of the
material drops below 100 grams. (Similarly, printing stops if the weight in
both cartridges is below this level.)
Note: Objet Studio does not display the weight of material in a cartridge if it is
under 100 grams.
¾ You can replace material cartridges either before or during printing. If you
do so while printing, make sure to load the new cartridge and close the
materials drawer within three minutes. This ensures that the print job is
not interrupted. (When the drawer is open, the cartridges are not
displayed in the printer interface.)
¾ If printing stops for an extended time before you replace a material
cartridge, the printer may go into Standby or Idle mode. If this happens,
see “Resuming Production After Printing has Stopped” on page 10.
¾ You can replace partially used cartridges to avoid the need for replacing
them during printing. However, repeated removal and installation of a
cartridge may cause the material in it to leak. Therefore, it is
recommended that you limit the re-installation of used cartridges.
To Next Page
Loading...
