Stratasys Objet24 - Setting the Printer Connection

DOC-34014 Rev. C 5–59
Objet24 User Guide
Setting the
Printer
Connection
WhenanObjet3Dprinterisinstalled,theservercomputerisconnectedto
thatprinter.Normally,thereshouldbenoreasontochangethisconnection.
Occasionally,however,youmayneedtoresettheconnection,toconnect
theservertoanotherprinter,ortouseObjetStudioinoff‐linemode
(without
aprinterconnection).
To set (or change) the printer connection:
1. OntheJobManagerribbon,inthe3DPrintergroup,click .
2. IntheSetPrinterdialogbox,click
Connect.
Figure 5-84: Connecting to a printer (A)
3. EnterthecomputernameoritsIPaddress,orclickBrowsetofindand
selectit.
Figure 5-85: Connecting to a printer (B)
4. ClickOK.
Whentheconnectionisestablished,ObjetStudioisconfiguredto
prepareprintjobsforthatprinter.
If you can see the material levels in the Job Manager screen (see
figure 5-83 on page 57), Objet Studio is connected to the printer.