Stratasys Objet24 - 3 D Model Preparation Workflow; CAD to STL Conversion

Installing Objet Software
4–2 DOC-34014 Rev. C
How to Install Software for the Objet 3D Printing System
TheObjetStudiosetupwizardguidesyouwheninstallingthissoftware.
ObjetStudioisinstalledontheprinter‐server(“host”)computer,butitcan
alsobeinstalledonremote,“client”computersandoncomputersusedto
preparefilesforprintingmodels,orfortraininganddemonstration
purposes.Duringinstallation,youchoose
toinstalleithertheprinter‐server
(“host”)applicationortheclientapplication.
To install Objet software:
1. InserttheObjetStudioCDintothediskdrive.
2. Right‐clickthe
StartbuttonandselectExplore(oruseanyothermethod
fordisplayingfilesonthecomputer).
3. OpentheCD‐drivefolderandselectSetup.
4. IfyouareinstallinganObjetStudioupgrade,makesurethatyour
printeriscompatiblewithitbycheckingthelistdisplayed.
Figure 4-1:Objet Studio compatibility check
5. ToinstallObjetStudio,youmustagreetothelicenseagreement.After
readingitsterms,click
Yestocontinue,orNotoclosethewizard.