Stratasys Objet24 - Freezing Model Orientation

Using Objet Studio
5–28 DOC-34014 Rev. C
To cancel plane selection after re-aligning objects on the build tray:
¾
OntheTraySettingsorModelSettingsribbon,click .
or—
¾ FromtheToolsmenu,selectPlane Alignment > Select Plane.
To flip an object 180 degrees on any axis:
1. Selecttheobject.
2. FromtheObjectmenu,select
Flip > Flip X / Flip Y / Flip Z.
To make precise changes to the object’s orientation on any axis:
1. Selecttheobject.
2. DisplaytheTransformdialogbox(seefigure 5‐30onpage 26).
3. Changethe
Rotateparametersforeachaxis.
Freezing Model
Orientation
Ifyoumanipulateanobjectonthebuildtray,youcanfreezeitsorientation
sothatitdoesnotchangewhenyoupositionitautomatically(see
“A u t o m a t i c Placement”onpage 19).
To freeze an object:
1. Selectanobjectonthebuildtray.
2. OntheModelSettingsribbon,intheManipulategroup,orontheModel
Toolbar,click .
To unfreeze an object:
¾
Selecttheobjectandclick(tode‐selectit).