Stratasys Objet24 - Page 164

Operating & Maintaining the Objet24 3D Printer
6–58 DOC-34014 Rev. C
5. DisconnecttheUVlampcableandthefancable.
Figure 6-86: Disconnecting the UV lamp assembly (top view)
6. LoosenthetwosidescrewssecuringtheUVlampassemblytothe
printer.
Figure 6-87: UV-lamp-assembly
7. Removetheassembly,andplaceitonaflatsurface.
UV-lamp connector
UV-fan connector
Securing
screws