The information contained in this document is confidential, and only for the information of the intended recipient and may not be published or redistributed without the prior written consent of Summa NV.
Summa nv Tel +32 59 27 00 11 Fax +32 59 27 00 63 Email support@summa.com Website www.summa.com Page 36 of 76
• The moveable rear media support roll at the back of the machine has to be set parallel with
the fixed media support roll: the same slot left and right has to be used.
• The front fixed support media roll (the brake roll) has to brake a bit. So if you turn the roll
quickly it should stop after one or two seconds. The rear support media roll has to turn further
for a while. Check if the spring on the break is in good condition.
• Use the core holders and core holder guides on the media support roll to ensure a good and
straight media loading. The core holders have to fit in the media guides both left and right.
• The vacuum fan may not work (see “Vacuum fan does not work”), or the vacuum holes in the
base plate may be clogged.
• Make sure the media was acclimatized.
To Next Page
Loading...
