Summa S CLASS - Concatenation; General; Media Sensor; Smoothing

S CLASS™ cutter User’s Manual
Detailed Operation 4-6
Smoothing:
The Smoothing feature helps to cut smoother curves when curve data with many short
vectors is received from the computer.
Press the button, then use or to set smoothing to ON or OFF.
Press
,
to confirm or to cancel.
The default setting is OFF.
Concatenation:
The Concatenation feature increases the speed and quality with which very high-resolution
cut data is cut. However, when changing over to normal characters again, deactivate
concatenation by setting this parameter to 0.
Press the button, then use or to change the value.
Press
,
to confirm or to cancel.
The default setting is 0.
4.3.1.3 General
Media sensor:
The media sensors detect whether media is loaded and also detect the end of the media.
The sensors prevent damage to the cutting strip and knife tip. The sensors can be activated
or deactivated with this menu.
When the sensors are activated, the cutter searches for the front end of the media during
the loading procedure. If it does not find it after returning the media for 1m (+/- 3 feet), it
stops returning the media and sets the origin in the x-axis there.
The cutter will also stop, during the loading procedure or while it is cutting, if the rear
sensor detects the end of the media.
The cutter does not search for the front end of the media and assumes that the loaded
media is endless if the sensors are not activated.
Press the button, then use or to activate (ON) or deactivate (OFF) both or
just front sensor (FRONT OFF) only.
Press
,
to confirm or to cancel.
The default setting for the media sensors is ON.