Summa S CLASS - Connecting the S CLASS Cutter Ad Hoc

S CLASS™ cutter User’s Manual
Setup 1-19
1.4.3.2 Connecting the S CLASS™ cutter ad hoc.
Ad-hoc networks connect to wireless devices with same SSID (network name) and
broadcasting on the same communication channel, with each other.
Following settings have to done for every device who is member of that ad-hoc network:
• Set same SSID on each device.
• Set same communication channel on each device.
• Set Unique IP address fro each device within same subnet (DHCP is not available).
• Set same subnet on each device.
• If one device is connected to the internet (and internet connection sharing is on for
that device), set the IP address of this device as gateway on each other device.
Setup parameters of the cutter:
The following procedure assumes a new cutter where the parameters for the wireless
connection have not been changed yet. If the parameters have already been changed, then
it is recommended to factory default the wireless parameters first (see Wireless:)
1. Power on the cutter.
2. Press .
The main menu will appear on the screen.
3. Press .
The settings menu will appear on screen.
4. Press .
The communication menu will appear on screen.
5. Press .
The wireless menu will appear on screen.
6. Press .
The LAN menu will appear on screen.
7. Press
.
The DHCP menu will appear on screen.
8. Use or to set DHCP to off.