S CLASS™ cutter User’s Manual
Detailed Operation 4-14
TurboCut:
TurboCut increases throughput without raising the overall speed of the plotter by speeding
up the drag movement. The cutting time reduction is significant, especially when cutting
small, detailed designs. However, some thicker materials might not cut well with this
feature turned ON.
Press the button, then use or to activate or deactivate TurboCut.
Press to confirm or to cancel. TurboCut is default activated.
FlexCut velocity:
FlexCut uses higher knife pressures. Higher knife pressures need lower cutting speed.
With this parameter the velocity of FlexCut can be set independent from the normal cutting
velocity.
NOTE: It is recommended to use speeds lower then 400mm/s for FlexCut.
To Next Page
Loading...
