S CLASS™ cutter User’s Manual
Setup 1-12
1.4.1.2 Connecting the S CLASS™ cutter to a Mac using a USB cable
Mac OS 8.5 to OS 9.2
1. Power off the cutter.
2. Connect one end of the USB cable to a USB port on the computer.
3. Connect the other end of the USB cable to the USB port on the back of the cutter.
4. Power on the cutter (see section 1.3.3) and return to the computer.
5. Insert the S CLASS™ CD into the computer’s CD-ROM drive.
6. Click on the “USB install driver” icon on the CD-ROM.
This will automatically install the driver and the Summa Port Mapper utility.
7. Remove the CD from the CD-ROM drive.
8. Restart the computer.
NOTE: If the cutter is connected to the computer before device installation, then the
computer will regard the cutter as an unknown device. The driver can be installed at any
time with or without the cutter connected.
Mac OSX
Most recent cutting software does not need a driver installation when a computer is
connected to the cutter. The software that controls the driver is built into the cutting
software.
To Next Page
Loading...
