Specifications 6-1
6 Specs and General Information
6.1 Introduction
The S CLASS™ range of cutters has been designed to produce computer-generated graphic
designs on cut sheet or roll vinyl media. Using the integrated optical positioning system
(OPOS) allows contour cutting of printed sheets of material. By replacing the knife with a
pen, these cutters can also be used to produce inexpensive previews of new graphic
designs on paper.
The following cutter models are currently available:
• The S75, which can handle media widths from 60 mm up to 840 mm (2.4” to 33”) and has
a drag knife.
• The S120, which can handle media widths from 115 mm up to 1300 mm (4.5” to 51”) and
has a drag knife.
• The S140, which can handle media widths from 170 mm up to 1450 mm (6.7” to 57”) and
has a drag knife.
• The S160, which can handle media widths from 170 mm up to 1680 mm (6.7” to 66”) and
has a drag knife.
• The S75 T, which can handle media widths from 60 mm up to 840 mm (2.4” to 33”) and
has a tangential knife.
• The S120 T, which can handle media widths from 115 mm up to 1300 mm (4.5” to 51”)
and has a tangential knife.
• The S140 T, which can handle media widths from 170 mm up to 1450 mm (6.7” to 57”)
and has a tangential knife.
• The S160 T, which can handle media widths from 170 mm up to 1680 mm (6.7” to 66”)
and has a tangential knife.
6.1.1 Product features
The following are the main features of the S CLASS™ cutters.
• Variable media widths.
To Next Page
Loading...
