S CLASS™ cutter User’s Manual
Setup 1-18
27. Enter the subnet mask. The subnet mask consists out of four 3-digit numbers. If the
subnet mask, received from the network administrator, has one or more numbers that
have less than a 3-digit number, and then precede them by as many 0’s as necessary to
get to a 3-digit number.
The subnet mask will appear on screen .
28. Press three times, then press .
The cutter will prompt the user to reboot the machine.
29. Do so.
After a reboot the cutter will show the assigned IP address on the bottom line of the screen.
This address is has to be used when installing the cutter in the cutting software.
Procedure when the wireless network uses MAC filtering:
Some wireless networks have an extra security feature called Mac address filtering. This
means that the network allows only known devices.
If the wireless network has MAC filtering enabled (check with network administrator), then
the MAC address has to be added to the list of accepted MAC addresses in the configuration
menu of the wireless access point before any settings are changed on the cutter. Following
procedure describes how to retrieve the MAC address:
1. Power on the cutter.
2. Press .
The main menu will appear on screen.
3. Press
.
The first part of the tests and setup menus will appear on screen.
4. Press .
The second part of the tests and setup menu will appear on screen.
5. Press .
The ROM revision will appear on screen
6. The last line on screen is the MAC address of the wireless module. Give this number to
the network administrator so that access can be granted for the cutter to the wireless
network.
To Next Page
Loading...
