S CLASS™ cutter User’s Manual
Setup 1-20
Off (inverse) will change.
9. Press to confirm.
The LAN menu will appear on screen.
10. Press .
The wireless menu will appear on screen.
11. Press .
The WLAN menu will appear on screen.
12. Press .
The mode menu will appear on screen.
13. Use or to choose the correct mode (Ad-hoc).
The chosen mode (inverse) will change.
14. Press to confirm.
The WLAN menu will appear on screen.
15. Press three times, then press .
The cutter will prompt the user to reboot the machine.
16. Do so.
This procedure will have set the WLAN and LAN parameters to its default values for an Ad-
hoc network.
Default values are:
SSID: SummaCutter
Channel: 9
Security: off
IP address: 192.168.1.100
Subnetmask: 255.255.255.0.
If needed, those values can be changed in the configuration menus of the WLAN and LAN
menu, but it is not recommended to do so.
If more then one cutter is setup in the ad-hoc network, then it is just the IP address needs to
be changed so that each cutter has an unique number. Only the three last numbers may be
changed to an unused number in the network.
To Next Page
Loading...
