S CLASS™ cutter User’s Manual
Setup 1-8
6. USB port: This interface is based on the standards specified in Universal Serial Bus
Specifications Revision 1.1. It allows a high-speed bi-directional communication
between the host computer and the cutter.
7. RS-232 port: This DB-9P connector provides serial bi-directional communication
between the cutter and a host computer.
8. Screws to secure the cutter base: Screws (3 left and 3 right) hold the cutter base to its
stand. All the screws must be properly tightened before using the cutter.
9. Tubes for media basket: Tubes in the back and front hold the media basket. They can
easily pulled outwards to put the basket in its place.
10. Casters: The casters on the stand are equipped with locking brakes. Once the cutter has
been moved to its new location, press the brakes with your foot to lock the casters.
11. Media basket: The stand and linen media basket come as standard equipment with all
S CLASS™ cutters.
12. Roll media guide bushes: The two flange guides serve to keep the media roll in place
when media is pulled from the roll.
13. Media support rollers: Rotating support rollers for the media roll.
To Next Page
Loading...
