7-1
CHAPTER
7
Removing and Replacing Storage
Devices
This chapter describes how to remove and replace the Sun Blade 150 storage devices.
This chapter contains the following topics:
■ Section 7.1, “Diskette Drive” on page 7-1
■ Section 7.2, “Smart Card Reader” on page 7-4
■ Section 7.3, “Hard Drives” on page 7-6
■ Section 7.4, “CD-ROM or DVD-ROM Drive” on page 7-11
7.1 Diskette Drive
To remove and replace the diskette drive, proceed as follows.
7.1.1 Removing the Diskette Drive
1. Power off the system, remove the system cover, and attach an antistatic wrist strap
as described in Chapter 5.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
2. If any long PCI cards are installed, remove them from the riser board connectors.
See Section 8.4.1, “Removing a PCI Card” on page 8-10.
3. If required, remove a diskette from the drive.
To Next Page
Loading...
