Sun Microsystems SUN BLADE 150 - Finishing Component Replacement; Replacing the System Cover

9-1
CHAPTER
9
Finishing Component Replacement
This chapter contains the following topics:
■ Section 9.1, “Replacing the System Cover” on page 9-1
■ Section 9.2, “Powering On the System” on page 9-2
9.1 Replacing the System Cover
1. Remove the wrist strap from the system chassis and from your wrist.
2. Position the system cover onto the system chassis.
Caution – Ensure that the hard drive cables will not be damaged when you replace
the system cover.
3. Slide the system cover toward the front of the system until the cover tabs lock
(
FIGURE 9-1).
4. Using a No. 2 Phillips screwdriver, replace the two screws securing the system
cover to the chassis.