2-2 Sun Blade 150 Service Manual • June 2002
2.2 SunVTS Requirements
Your system must meet the following requirements to run SunVTS:
■ The SunVTS packages must be installed. The main package is SUNWvtx for 64-bit
systems. There are additional supporting packages that differ based on the
version of the Solaris operating environment that is installed. For specific details,
refer to the corresponding SunVTS documentation (described below).
■ The system must be booted to the multiuser level (level 3).
■ To run SunVTS with a GUI, that GUI must be installed. Otherwise, run SunVTS
with the TTY-mode interface.
2.3 SunVTS References
To find out more information about the use of SunVTS, refer to the SunVTS
documentation that corresponds to the Solaris software version that you are
running.
The following list describes the contents of each SunVTS document:
■ SunVTS 4.x User’s Guide describes how to install, configure, and run the SunVTS
diagnostic software.
■ SunVTS 4.x Quick Reference Card provides an overview of how to use the SunVTS
CDE interface.
■ SunVTS 4.x Test Reference Manual provides details about each individual SunVTS
test.
These documents are part of the Solaris on Sun Hardware AnswerBook2 collection.
The part number for each document is different for each version of Solaris: check the
version of Solaris that you are using and find the appropriate part number for the
document. This collection is distributed on the Sun Computer Systems Supplement CD
with each SPARC Solaris release and is also accessible at http://docs.sun.com.
To Next Page
Loading...
