A-6 Sun Blade 150 Service Manual • June 2002
A.5.3.2 Ejecting a CD From the CD-ROM or DVD-ROM Drive
To eject a CD, press the eject button on the front of the drive.
It may be necessary to unmount the CD before manually ejecting it. You can also
eject the CD by using software commands. Refer to the peripherals handbook that
corresponds with your operating environment.
If the motorized eject mechanism does not operate, insert a thin, stiff wire (such as a
paper clip) into the hole next to the eject button to manually eject the CD.
A.5.3.3 Cleaning the CD-ROM or DVD-ROM Drive
If the CD-ROM or DVD-ROM drive cannot read a CD, the cause might be a dirty
CD. Follow these guidelines to clean a CD:
Caution – Do not use solvents such as benzine, paint thinner, antistatic aerosol
spray, or abrasive cleaners to clean CDs.
■ Use a professional CD cleaning kit.
■ Use a soft, clean, lint-free, dry cloth.
■ Clean the unlabeled side of the CD.
■ Wipe the CD radially from the center to the outside.
A.5.3.4 Handling and Storing CDs
Follow these guidelines when handling and storing CDs:
■ Handle CDs only by their edges; avoid touching CD surfaces.
■ Do not write on CDs with permanent marking pens.
■ Do not use CDs in high-dust environments.
■ Keep CDs out of direct sunlight, away from extreme sources of heat or cold, and
away from dust and moisture.
■ Make sure CDs are at room temperature before using them.
■ Store CDs in storage boxes so that they remain clean and free of dust.
A.6 Modem Setup Specifications
■ Section A.6.1, “Setting Up the Modem” on page A-7
■ Section A.6.2, “Changing the Serial Port Speed” on page A-8
■ Section A.6.3, “Modem Recommendations” on page A-9
To Next Page
Loading...
Need help?
General
