Sun Microsystems SUN BLADE 150 - Diag-Level Variable Set to Min

3-18 Sun Blade 150 Service Manual • June 2002
3.6.2 diag-level Variable Set to min
When you set the diag-level variable to min, POST enables an abbreviated set of
diagnostic-level tests. This mode requires approximately one minute to complete
(with 128 Mbytes of DIMM installed).
CODE EXAMPLE 3-2 shows a serial port POST
output with diag-level set to min and a single 512 Mbyte DIMM installed.
PC = 0000.01ff.f000.297c
PC = 0000.0000.0000.29c0
Decompressing into Memory Done
Size = 0000.0000.0006.1780
ttya initialized
Reset Control: BXIR:0 BPOR:0 SXIR:0 SPOR:0 POR:1
Probing upa at 1f,0 pci
Probing upa at 0,0 SUNW,UltraSPARC-IIe (512 KB)
Loading Support Packages: kbd-translator
Loading onboard drivers: ebus flashprom eeprom idprom
Probing Memory Bank #0 256 Megabytes
Probing Memory Bank #1 256 Megabytes
Probing Memory Bank #2 256 Megabytes
Probing Memory Bank #3 256 Megabytes
Probing /pci@1f,0 Device 7 isa dma floppy parallel power serial
serial
Probing /pci@1f,0 Device c network firewire usb hub keyboard mouse
storage
Probing /pci@1f,0 Device 3 pmu i2c temperature card-reader dimm
dimm
dimm dimm ppm beep fan-control
Probing /pci@1f,0 Device 8 sound
Probing /pci@1f,0 Device d ide disk cdrom
Probing /pci@1f,0 Device 13 SUNW,m64B
Probing /pci@1f,0 Device 5 pci
Probing /pci@1f,0/pci@5 Device 0 Nothing there
Probing /pci@1f,0/pci@5 Device 1 Nothing there
Probing /pci@1f,0/pci@5 Device 2 Nothing there
Sun Blade 150 (UltraSPARC-IIe 650MHz), Keyboard Present
Copyright 1998-2002 Sun Microsystems, Inc. All rights reserved.
OpenBoot 4.6, 1024 MB memory installed, Serial #51602330.
Ethernet address 0:3:ba:13:63:9a, Host ID: 8313639a.
CODE EXAMPLE 3-1 diag-level Variable Set to max (Continued)