3-16 Sun Blade 150 Service Manual • June 2002
................................................................
Status of this POST run: PASS
diag-script=none
Time Stamp [hour:min:sec] 15:20:37 [month/date year] 04/23 2002
Power On Selftest Completed
Status = 0000.0000.0000.0000 ffff.ffff.f00b.63f0
0002.3333.0200.001b
Speed Jumper is set to 0000.0000.0000.0008
Software Power ON
@(#)OBP 4.6.0 2002/04/03 12:28
CPU SPEED 0x0000.0000.26be.3680
Initializing Memory Controller
MCR0 0000.0000.76a0.cf04
MCR1 0000.0000.8000.8000
MCR2 0000.0000.cff0.eeee
MCR3 0000.0000.0060.0052
Clearing E$ Tags Done
Clearing I/D TLBs Done
Probing Memory Done
Clearing Memory Done
MEM BASE = 0000.0000.c000.0000
MEM SIZE = 0000.0000.1000.0000
MMUs ON
Copy Done
PC = 0000.01ff.f000.297c
PC = 0000.0000.0000.29c0
Decompressing into Memory Done
Size = 0000.0000.0006.1780
ttya initialized
Reset Control: BXIR:0 BPOR:0 SXIR:0 SPOR:1 POR:0
Probing upa at 1f,0 pci
Probing upa at 0,0 SUNW,UltraSPARC-IIe (512 KB)
Loading Support Packages: kbd-translator
Loading onboard drivers: ebus flashprom eeprom idprom
Probing Memory Bank #0 256 Megabytes
Probing Memory Bank #1 256 Megabytes
Probing Memory Bank #2 256 Megabytes
Probing Memory Bank #3 256 Megabytes
CODE EXAMPLE 3-1 diag-level Variable Set to max (Continued)
To Next Page
Loading...
