IGNITION AND ELECTRICAL 3-11
8. Loosen the PORT side bolt 6 securing starter motor band.
9. Remove the three (3) screws securing battery charge & con-
denser charge coil 7.
Remove the two (2) screws securing pulser coil 8.
Remove the six (6) bolts securing stator base 9.
10. Cut the cable ties 0 securing pulser coil wiring harness to
stator base.
11. Disconnect the 4-pin wiring harness connector from CDI
unit.
12. Lift up and remove stator base from cylinder block.
13. Cut the cable ties securing coil wiring harness to stator base.
14. Disconnect battery charge coil lead wire connector from rec-
tifier.
15. Remove the bolt A securing pulser coil GND lead wire.
16. Remove the battery & condenser charge coil.
To Next Page
Loading...
