Symmetricom TimeSource 3100 User Guide

097-72020-01 Revision K – December 2005 TimeSource User’s Guide 101
Chapter 4 TL1 Reference
Commands
Commands
The commands used with the TimeSource 3100 are listed on the following pages.
After the command name, a definition of the command is given. The definition is
followed by the actual command, followed by the variables that can be used with the
command.
The response format shows how the response will appear, with additional
definitions of the response parameters where required.
Display information about equipment Retrieve Inventory 145
Display alarm log data Retrieve Log 147
Display performance monitoring data Retrieve Performance
Monitoring
148
Display security parameters for a single user or for
all users
Retrieve User Security 157
Set the name of the equipment Set Source Identifier 158
Table 4-2. Commands for Tasks (Continued)

Symmetricom TimeSource 3100 Specifications

General

Brand	Symmetricom
Model	TimeSource 3100
Category	GPS
Language	English