Chapter 4 TL1 Reference
Commands
104 TimeSource User’s Guide 097-72020-01 Revision K – December 2005
Copy Memory
This command copies a software program from an external computer to the
TimeSource 3100, or copies the system database to nonvolatile memory.
To copy a program from an external computer to nonvolatile memory within the
TimeSource 3100, the command format is:
CPY-MEM:[<tid>]:<aid>:<ctag>::AUX,,WKG:PGM;
Command Example:
CPY-MEM::TS3100:<ctag>::AUX,,WKG:PGM;
Response Format:
<sid> <date> <time>
M <ctag> COMPLD
/*LINK:<link>,CMD:<command>*/
;
Notes:
1. Clear any existing alarms before using this command.
2. The database is automatically copied to nonvolatile memory once
per hour. However, if power to the TimeSource 3100 is
interrupted before the automatic copying occurs, changes made
since the last automatic copy will be lost. To avoid the possibility
of losing database changes, the Copy Memory command may be
used to copy database changes to nonvolatile memory after any
changes are made.
Aid Item Addressed
TS3100 System software
GPS GPS receiver software
DEV2 TimeSource 3100 without module (990-72020-01 systems)
DEV4 TimeSource 3100 with module for TOD IRIG-B outputs
(990-72020-05 systems)
DEV6 TimeSource 3100 with module for additional E1 or 2.048 MHz
outputs (990-72020-02 systems)
DEV8 TimeSource 3100 with module for ESCIU ports
(990-72020-04 systems)
DEV10 TimeSource 3100 with mixed E1/T1 cards
(990-72020-06 systems)
To Next Page
Loading...
Need help?
General
