Chapter 4 TL1 Reference
Commands
108 TimeSource User’s Guide 097-72020-01 Revision K – December 2005
Edit Communication
This command changes communication port parameters. The command format is:
ED-COM:[<tid>]:<aid>:<ctag>:::<spec_block>;
The parameters which can be entered in the <spec_block> are listed below. For any
specific <aid> entered in a command, only certain parameters are valid. For each
valid parameter, choose the appropriate value from the Value column. When
entering multiple parameters, separate the parameters with commas.
Aid Value Item Addressed
COM-a a = 1 Serial communication port 1 (COM1)
a = 2 Serial communication port 2 (COM2)
a = 3 Serial communication port 3 (Craft)
a = 5001
Ethernet user interface port 5001
a
Note:
a
Ethernet ports 5001, 5002, 5003, and 5004 are set up to act as serial communication
ports, so that a terminal program on a computer connected to these ports can com-
municate effectively.
a = 5002
Ethernet user interface port 5002
1
a = 5003
Ethernet user interface port 5003
1
a = 5004
Ethernet user interface port 5004
1
a = 5551
Ethernet element manager interface port 5551
b
(Note 2)
b
Ethernet port 5551 is set up to allow an element manager to connect with it for TL1
commands and responses. TL1 autonomous messages are sent through port 5550,
which connects to an element manager to send one or a group of autonomous mes-
sages, then disconnects. Port 5550 is not to be reconfigured.
To Next Page
Loading...
Need help?
General
