Chapter 4 TL1 Reference
Commands
120 TimeSource User’s Guide 097-72020-01 Revision K – December 2005
4. When setting alarm integration time (SEVERITY or SERAFF), the type of alarm
(HOLDOVER, GPS, LOS, AIS, or ERROR) has to be specified. For example,
ED-EQPT::TS3100:CTAG::: ALARM=HOLDOVER, TIME=72-00,
SEVERITY1=EV, SERAFF1=NSA, SEVERITY2=MJ, SERAFF2=SA; will
generate a holdover event as soon as the condition is detected with an NSA flag.
Once this condition has existed for 72 hours, TS3100 will generate a major alarm
with an SA flag. These parameters can then be verified using the RTRV-EQPT
command.
5. If the dbinit jumper is changed, the NTP password has to be re-entered.
6. A remote oscillator must have been put into service before using the ENT-EQPT
command before setting the ENSEMBLER parameter.
7. A span must have been put into service using the ENT-EQPT command before
setting the ENSEMBLER and SSM parameters.
8. The span must be put into service using the ENT-EQPT command before using
this parameter.
9. All commands on DCDUSERPORT having TID which equal SID of the DCD are
forwarded to the DCD. Similarly, the responses from the DCD are sent to the
provisioned DCDUSERPORT.
Response Format:
<sid> <date> <time>
M <ctag> COMPLD
/*LINK:<link>,CMD:<command>*/
;
The flow chart in Figure 4-4 illustrates the alarm conditioning possible with the
TimeSource 3100.
To Next Page
Loading...
Need help?
General
