Tascam Sonicview 16 - Page 76

4 – Mixer configuration and settings
Dante Network Settings
This shows the status of the Dante network settings for the
SB-16D.
When in Redundant mode, settings will be shown for
the Primary connector on the left and for the Secondary
connector on the right.
When in Switched (daisy-chain) mode, only the left side will
be active.
Item Content
Switch
This shows the selected connection mode.
Tap this area to open a window where
Redundant or Switched mode can be
selected. (default: Redundant)
Addressing
This shows the IP address setting mode.
Tap this area to open a window where
AUTO (DHCP) or STATIC can be selected.
(default: AUTO (DHCP))
IP Address
If the Addressing item is set to “AUTO”,
this will show the assigned IP address. If
it is set to “STATIC”, this will show the IP
address set by the user.
When the Addressing item is set to
“STATIC”, tapping this area will open the
IP ADDRESS Screen. (See “IP Address/
Subnet Mask/Default Gateway setting
procedures” on page 91.)
Subnet mask
If the Addressing item is set to “AUTO”, this
will show the assigned subnet mask. If it
is set to “STATIC”, this will show the subnet
mask set by the user.
When the Addressing item is set to
“STATIC”, tapping this area will open the
SUBNET MASK Screen. (See “IP Address/
Subnet Mask/Default Gateway setting
procedures” on page 91.)
LINK Status
This shows the Dante network link status.
This will be shown in red if it is not 1 G.
MAC Address
This shows the MAC address of the
Primary/Secondary Dante port.
To confirm Dante network settings for the SB-16D, the SB-
16D Dante module must be restarted.
If SB-16D Dante network settings have been changed, the
APPLY button will appear highlighted.
Tap the APPLY button when it is highlighted to open a
confirmation message.
Since tapping the CANCEL button will not restart the unit,
the settings will be as is but will not be applied to operation.
Tap the REBOOT Dante button to confirm the changes and
restart the SB-16D Dante module.
After restarting, the settings will be applied to operation.
ATTENTION
Be aware that SB-16D Dante input and output sound will be
interrupted while the SB-16D Dante module is restarting.
76 TASCAM Sonicview 16/Sonicview 24 V1.1.0