TB30s SIP Administrator Guide v1.3 Page 129 of 259
Feature Activation
A new parameter is needed to configure this function and with some
additional definitions listed below.
call_hold_method=<0|1>, 0 is by default
call_hold_method=0, “send-only” call-hold method is used
call_hold_method=1, “inactive” call-hold method is used
Via APS:
APS in [sip] section of both Common and Specific-MAC config files with the
new parameter:
[sip]
…
call_hold_method=0 // by default, “send-only” is in use
…...
Via Telnet
To configure, open a command line console, and telnet the phone:
To Next Page
Loading...