TB30s SIP Administrator Guide v1.3 Page 70 of 259
Display Customer Icon in Standby (3959) – v1.72
INTRODUCTION
We have a customer that is requesting a new feature on TB30: Display on his Logo
icon.
Requirement
- Standby (for SIP only):
o After a time out the Phone displays the Logo Icon.
o Default (empty)
Standby
In standby mode, the logo can be turn on or off. This logo displays in the middle 4 line of the
screen (except 1st line and last line).
So it will not cover the softkey and some information. This logo can download by APS. It
should support bitmap file format.
If there is a message (Missed call, CHP Supervision & SIP message) on the display, it should
blink between the logo and the message.
A new parameter is added for APS.
app_logo_bmp=xxxx.bmp (B/W bitmap file only and the bitmap with inverted)
Icon Size = 240 x 80
To clean the icon:
app_logo_bmp= <empty>
The upgrade behavior is same as language table. It will include in XXX.inf file. Format as
below:
XXX.inf with tftp
Tone_table=xxxx
Language_table=xxxx
app_logo_bmp=xxxx.bmp
xxx.inf with http
tone_table=http://path/filename
language_table=http://path/filename
To Next Page
Loading...
Need help?
General