TB30s SIP Administrator Guide v1.3 Page 240 of 259
Supported TR069 RPC methods with TB30
List of supported RPC in TB30
Table.1
ACS HTTP connection flow
Using the HDM ACS will launch the TR-069 RPC on the CPE, e.g. a
GetParameterValues RPC. This will result in a CWMP session between the CPE and
ACS which spans several http requests/response cycles
CPE is driving the HTTP connection to the ACS, only the CPE is responsible for connection initiation and
teardown.
All transaction sessions must begin with an Inform message from the CPE contained in the initial
HTTP post.
CPE is responsible for terminating the transaction session, while the ACS could just consider the
session terminated.
This specification does not say that there should be a persistent connection between the CPE and
the ACS.
See the following figure:
To Next Page
Loading...