TB30s SIP Administrator Guide v1.3 Page 174 of 259
Feature Activation
A) Through the WebGui:
The activation of this feature is accessible from:
B) Through APS:
For this purpose, new parameters have been included in the [sys] section of
the Common/MAC config files, to be able to configure the feature.
[sys]
Current_Max_Multiline=5
FeatureKeyExt09=S/<sip:2209>
FeatureKeyExt10=V/<sip:*8|1103|#>
C) Through Telnet:
For this purpose, existing parameters are used, described as follows:
sys set fkuri id(1~66) uri_string
sys set fktype id(1~66) 0/1/2/3/4/5/6/7 (L/S/E/R/G/B/D/V)
Behavior
1. Press the Function key
2. The phone will display "Enter a number" displaying also the programmed
number.
3. User will modify or not that number, and then press OK to dial out.
4. The phone will send an INVITE with TO header = SC + phoneNr + SC
If you press the FK during a call, it will be treated as another call (so the
phone will put the current active call on hold, perform the action, and will
wait for user to go back to the active call).
Call Flow:
To Next Page
Loading...
Need help?
General