TB30s SIP Administrator Guide v1.3 Page 233 of 259
Part 12 Telnet Activation
Introduction
This part reviews and summarizes TB30 Telnet commands useful for remote
management of the phone.
Other commands (like configuration of the phone‟s parameters) are described in
another Technical document: “TB30 Config file Syntax”. It is issued in the firmware
release package.
Enable Telnet service
By default, the Telnet service is disabled for security reasons.
So the Telnet service must be enabled before trying to open a telnet session on the
phone.
Enter the following URL on you web browser:
http://ip_address_of_the_phone/telnet.html
Then enter the username and password (same as the web interface):
Username (default): administrator
Password (default): 784518
To Next Page
Loading...