TB30s SIP Administrator Guide v1.3 Page 72 of 259
Reset to default single parameter (3864) – v1.72
INTRODUCTION
For the current implementation of APS mechanism, if the value is empty of some parameter, we
don‟t change anything, for example, if you set “CWMPACSUser=” in
ComConfTB30S_100204.txt, it will follow the setting you set before, so if you want to change
this parameter for blank in this version, you must reset to default. So it is no way to set the
parameter to empty.
As a result two keywords <default> and <empty> are defined.
CWMPACSUser=<default> will set to default value after APS.
CWMPACSUser=<empty> will set to empty value after APS.
Remark: <empty> is only apply for string parameter.
To Next Page
Loading...