Product maintenance
Product maintenance
The following information applies to the TG8000 mainframe and all of its
associated generators and modules. Before you perform maintenance procedures
on the produc
t, read the following information in this section:
Service preparation (See page 1-4.)
Inspection and cleaning (See page 1-6.)
Module installation and removal (See page 1-10.)
Repackaging instructions (See page 1-16.)
If the instrument does not function properly, troubleshooting and corrective
measures should be taken immediately to prevent additional problems.
NOTE. Contact your local Tektronix representative for information on where to
return your instrument if it requires repair during the warranty period.
Service preparation
Read a
nd follow these preparation instructions before attempting to perform any
maintenance or service to the instrument.
Servicing prerequisites
Ensure the following before beginning any instrument service:
The maintenance or service of this instrument m ust be performe d by qualified
service personnel only.
Read the General safety summary and the Servicesafetysummarylocated at
the beginning of this manual before attempting to perform any maintenance
or
service to the instrument.
1–4 TG8000 Multiformat Test Signal Generator Service Manual
To Next Page
Loading...
Need help?
General
