EasyManuals Logo

Tektronix TG8000 Service Manual

Tektronix TG8000
372 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #349 background imageLoading...
Page #349 background image
SDI7 module adjustment procedures
31. Press the right
()arrowbuttontoselect20 Bits Square, and then press
the ENTER button.
32. Repeat steps 1
8 through 24 for the Signal 2A output.
33. Move the 1 m high-bandwidth cable from the SDI7 Signal 2A output to the
Signal 2B ou
tput.
34. Use the left () or right () arrow buttons to select Channel 2: Bottom to
adjust the S
ignal 2B output, and then press the ENTER button.
35. Press the right ()arrowbuttontoselect20 Bits Square, and then press
the ENTER b
utton.
36. Repeat steps 18 through 24 for the Signal 2B output.
37. Cycle the power on the TG8000 to return the generator to normal operating
mode.
TG8000 Multiformat Test Signal Generator Service Manual 14–9

Table of Contents

Other manuals for Tektronix TG8000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix TG8000 and is the answer not in the manual?

Tektronix TG8000 Specifications

General IconGeneral
BrandTektronix
ModelTG8000
CategoryPortable Generator
LanguageEnglish

Related product manuals