64
PREPARATIONS
• When the setting of "OUTPUT DATA TYPE" is TONO or T/P:
MODE1(average value output format);
MODE2(latest value output format;
STD1 (TOPCON STD1 format);
STD2 (TOPCON STD2 format); or
STD3 (TOPCON STD3 format)
• When the setting of "OUTPUT DATA TYPE" is PACHO or ALL:
STD3 (TOPCON STD3 format); or
CM6 (custom specification)
4 Press the Set item change button ; the cursor goes to the next item.
When outputting all data of ocular pressure measurement value, select "STD2" or
"STD3".
For inquiries about the RS-232C communication format, call your dealer or Topcon
at the address stated on the back cover.
When data is outputted from the USB OUT terminal, either STD1, STD2 or STD3
is taken regardless of setting here.
To Next Page
Loading...
Need help?
General
