Toshiba B-EP Series - Page 121

- 112 -
(2) Assembly process test print mode
Power OFF
(1) Power off state
(2) While holding down the [FEED] key, press the
[POWER] key to turn the power on.
[FEED] [POWER]
< 0 > S H U T D O W N
(3) System mode menu display (Shutdown)
[PAUSE]
(4) Press the [PAUSE] key.
< 1 > D I A G N O S T I C
(5) System mode menu display (Self-test)
[PAUSE] (6) Press the [PAUSE] key.
< 2 > M O D E S E T T I N G
(7) System mode menu display
(Mode setting)
[PAUSE] (8) Press the [PAUSE] key.
< 3 > P A R A M E T E R S E T
(9) System mode menu display
(Parameter setting)
[PAUSE]
(10) Press the [PAUSE] key.
< 4 > A D J U S T S E T
(11) System mode menu display
(Fine adjustment value setting)
[PAUSE] (12) Press the [PAUSE] key.
< 5 > T E S T P R I N T
(13) System mode menu display (Test print)
[POWER] (14) Press the [POWER] key.
P R I N T C O N D I T I O N
(15) Test print condition parameter setting mode
[PAUSE] x6 (16) Press the [PAUSE] key six times.
F A C T O R Y T E S T
(17) Assembly process test line print mode
[PAUSE] (18) Press the [PAUSE] key.
A U T O P R I N T ( T R A N )
(19) Assembly process automatic print mode
(transmissive sensor)
[PAUSE] (20) Press the [PAUSE] key.
A U T O P R I N T ( R E F L )
(21) Assembly process automatic print mode
(reflective sensor)
[PAUSE] (22) Press the [PAUSE] key.
P R O C E S S P R I N T
(23) Assembly process test pattern print mode
[FEED] + [PAUSE] (24) While holding down the [FEED] key, press the
[PAUSE] key.
< 5 > T E S T P R I N T
(25) System mode menu display (Test print)