Toshiba B-EP Series - Mode Setting Items

- 17 -
O N L I N E
(29) The printer returns to the same state as when
the power is turned off and on again.
5.13.2 Mode Setting Items
For details, refer to the section, “6.6.3 Various Parameter Settings” in Chapter “6. SYSTEM
MODE” (for system administrators).
Item Default
Print command language
setting
(PCL Mode)
TPCL
Head division setting
(HEAD DIV)
B-EP2:
AUTO1 (automatic selection from none, 2 or 3 division)
B-EP4:
AUTO1 (automatic selection from none, 2, 3 or 6 division)
B-SP series compatibility mode
setting
(B-SP MODE)
OFF (B-SP series compatibility mode is disabled.)
Linerless setting
(LINERLESS)
OFF (Linerless setting is disabled.)
Print type setting
(PRINT TYPE)
AUTO (automatic selection from BATCH or STRIP)
Post-print stop position setting
(PAPER STOP)
CUT (Stop at the cut position)
* Supported on V1.0E or later.
Back feed restriction setting
(BF.RESTRICT)
ON (Back feed restricted)
* Supported on V1.0E or later.
Strip issue back feed setting
(PEEL BF.)
OFF (No back feed allowed)
* Supported on V1.0E or later.