- 78 -
6.6.2.2.8 Strip Issue Back Feed Setting (PEEL BF.) * Supported on V1.0E or later.
When strip position fine adjustment is set to – (negative) by using a command or in system mode,
the strip position is finely adjusted and the printing is misaligned simultaneously. This setting is
used to perform a back feed and thus correct the print position for the purpose of printing on the
normal position.
P E E L B F . O F F
Performs no back feed.
[PAUSE]
P E E L B F . O N
Performs a back feed.
[PAUSE]
Default value: OFF (No back feed performed)
<Commentary>
y When the gap length is 5 mm or more, printing is not misaligned on the label, although the strip
position fine adjustment is set to - (negative). Therefore, no back feed is performed when ON
(back feed performed) is selected in this setting.
<Supplemental Explanations>
y When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE]
key is pressed.
y When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
y When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this parameter
setting, repeat mode is enabled and the key pressed is repeatedly entered.
y The change in the parameter setting becomes effective when the [POWER] key is pressed after
setting, then stored in the backup memory.
To Next Page
Loading...
