Toshiba B-EP Series - Paper Feed Mode Setting (PAPER)

- 120 -
6.6.5.2.7 Paper Feed Mode Setting (PAPER)
This setting is used to feed a paper without performing printing in system mode where the [FEED]
key is invalid to feed a paper.
P A P E R N O F E E D
Paper is not fed.
[PAUSE]
P A P E R F E E D
Paper is fed.
[PAUSE]
Default value: NO FEED
<Supplemental Explanations>
y When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE]
key is pressed.
y When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
y When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this setting, repeat
mode is enabled and the key pressed is repeatedly entered.
y The change in the parameter setting becomes effective when the [POWER] key is pressed after
setting, then stored in the backup memory.
y By selecting an option using the [FEED] key and determining it using the [POWER] key feeds the
paper by an amount specified by LABEL LEN. (See the previous section.). If the label length is not
specified, the paper is fed by 63 mm.
y The default value at power on is NO FEED (Paper is not fed.).