Toshiba B-EP Series - Sensor Setting (SENSOR)

- 117 -
6.6.5.2.4 Sensor Setting (SENSOR)
This setting selects a sensor to be used.

 
S E N S O R N O N E
No sensors used, i.e. position is not detected
(when using receipt paper)
[PAUSE]
S E N S O R T R A N S .
Transmissive sensor (when using tag paper
with black mark)
[PAUSE]
S E N S O R R E F L E C T .
Reflective paper (when using label paper)
 [PAUSE]
Default value: NONE (No sensors used, i.e. position is not detected)
<Supplemental Explanations>
y When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE]
key is pressed.
y When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
y When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this setting, repeat
mode is enabled and the key pressed is repeatedly entered.
y The change in the parameter setting becomes effective when the [POWER] key is pressed after
setting, then stored in the backup memory.
y The default value at power on is NONE (No sensors used, i.e. position is not detected).