Toshiba B-EP Series - 6.6 LCD Display at Startup

- 35 -
5.20 LCD MESSAGES AND LED INDICATIONS
On the character display LCD, model and firmware version are displayed.
No.
LCD Message
LED
Indication
Printer Status
Recoverable
by the
[PAUSE] key
Acceptance
of Status
Request
and
(English)
Status
Yes/No
Reset
Commands
Yes/No
1
ON LINE
{
Online mode
- Yes
ON LINE
{
Online mode (communicating)
- Yes
LBL PRESENT ****

Strip wait
- Yes
2
COVER OPEN
{
The cover was opened in online state.
- Yes
3
PAUSE ****
z
Pause state
Yes Yes
4
COMMS ERROR
U
A parity error, overrun error, or a framing
error occurred during communication by
RS-232C.
Yes Yes
5
PAPER JAM ****
U
A paper jam occurred during paper feed.
Yes Yes
6
NO PAPER ****
U
The label has run out.
Yes Yes
7
NO PAPER
U
The label has run out after issuing the label
successfully.
Yes Yes
8
COVER OPEN ****
U
A feed or an issue was attempted with the
cover opened.
(except when the [PAUSE] key is pressed)
Yes Yes
9
HEAD ERROR
U
A broken dots error occurred in the thermal
head.
Yes Yes
10
EXCESS HEAD TEMP
U
The thermal head temperature is extremely
high (71°C or more).
No Yes
11
SAVING #### &&&&
{
In writable character or PC command save
mode
- Yes
12
FORMAT ERROR
U
An error occurred in formatting the flash
ROM on the CPU board.
No Yes
13
FLASH WRITE ERR.
U
An error occurred in writing data into the
flash ROM on the CPU board.
No Yes
14
FLASH MEM FULL
U
Saving failed due to insufficient memory
capacity of the flash ROM on the CPU
board.
No Yes
15
EEPROM ERROR
U
Data cannot be read from/written to a
backup EEPROM properly.
No No
16
LOW BATTERY
U
The battery voltage
B-EP2: 7.2V or less
B-EP4: 14.0V or less
No Yes
17
AMBIENT TEMP ERR
U
An ambient temperature is below -20°C or
over 60°C.
Yes Yes
18
BATT. TEMP ERROR
U
The battery is in a dangerous condition.
Care must be taken not to get burned.
No Yes
19
HIGH VOLT. ERROR
U
The battery is in a dangerous condition.
No Yes