- 202 -
6.11 LCD FUNCTIONS
The LCD displays printer status messages.
The battery level mark and the external power source mark are updated every 5 seconds.
LCD size: 16 digits × 1 line
NOTE: When turning on the printer power on, press the [POWER] key after the battery level mark and
the external power source mark turn on, 2 to 5 seconds after the AC adopter is connected.
Otherwise, the LCD display may not be as expected or it may take a longer time for the printer
to start up.
Not displayed in system mode.
Link mark: Indicates a connection status with an access point
for wireless LAN models
ON: Not connected
OFF: Connected
Blink: Roaming
Communication mark: Indicates a data communication status.
OFF: No communication
ON: Sending
ON: Receiving
ON: Sending & receiving
Error mark: Indicates a printer error status.
OFF: Not in error state
ON: In error state
External power source mark: Indicates a connection status with
an AC adaptor.
OFF: Not connected
ON: Connected
Battery level mark: Indicates a remaining battery power level.
ON: (Level1) Inoperative (low battery)
ON: (Level2) Low (near-low battery)
ON: (Level3) Medium
ON: (Level4) High
ON: (Level5) Full (full charge)
Charge status mark:
Blink: Charging
ON: Full charge
Radio intensity mark:
Indicates a radio intensity level (when wireless LAN is enabled (WLAN=ON)
for the wireless LAN model).
WLAN mode: INFRA
ADHOC
ON: Out of range ON: Paused due to wrong setting
ON: X ≤ -90 dbm
ON: -90 dbm < X ≤ -80 dbm
ON: -80 dbm < X ≤ -70 dbm ON: In operation
ON: -70 dbm < X
To Next Page
Loading...
