Toshiba B-EP Series - Test Print Condition Parameter Setting (PRINT CONDITION)

- 115 -
6.6.5.2.2 Test Print Condition Parameter Setting (PRINT CONDITION)
 
P R I N T C O N D I T I O N
Print condition parameter setting
[POWER]
I S S U E C O U N T 1
Issue count
[POWER]
S E N S O R N O N E
Sensor setting
[POWER]
T Y P E A U T O
Print type setting (BATCH/STRIP)
[POWER]
L A B E L L E N . 6 3 m m
Label length setting
[POWER]
P A P E R N O F E E D
Paper feed mode
[POWER]
< 5 > T E S T P R I N T
Test print mode
[POWER]
S L A N T L I N E ( 1 D O T )
1-dot slant line print mode

Moves to the test print mode selected.
<Supplemental Explanations>
y When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE]
key is pressed.
y When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
y When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this setting, repeat
mode is enabled and the key pressed is repeatedly entered.
y The change in the parameter setting becomes effective when the [POWER] key is pressed after
setting, then stored in the backup memory.
y The default value at power on is PRINT CONDITION (test print condition parameter setting).