Toshiba B-EP Series - Self-Test Result Items

- 57 -
6.6.1.3 Self-test Result Items
(1) Maintenance counter values
Item Description Range
TOTAL FEED Total label distance covered
(cannot be cleared)
0.0 to 320000.0 m
in units of 10 cm
TOTAL PRINT Total label print distance covered
(cannot be cleared)
0.0 to 320000.0 m
in units of 10 cm
FEED Current label distance covered 0.0 to 320000.0 m
in units of 10 cm
FEED (1 to 4) Previous label distance covered
1 to 4
0.0 to 320000.0 m
in units of 10 cm
PRINT Current label print distance 0.0 to 320000.0 m
in units of 10 cm
PRINT (1 to 4) Previous label print distance
1 to 4
0.0 to 320000.0 m
in units of 10 cm
232C ERR RS-232C hardware error count 0 to 255
SYSTEM ERR System error count 0 to 15
* For details, refer to the section, “6.6.8.2.3 Maintenance Counter Clear”
Maintenance Counter Count Conditions
Total label distance covered
Label distance covered
Counts whenever the paper feed motor is driven, for
example, to feed, print, or exit a label. (Also counts during
a reverse feed operation.)
When the power is turned off, a label distance of up to 50.0
cm may be rounded down and backed up.
When the label distance covered reaches the maximum
value, the maintenance counter must be cleared.
Otherwise, the total label distance covered cannot be
updated.
Label print distance Counts while printing. (Counting is not performed during a
paper exit or reverse feed operation.)
When the power is turned off, a print distance of 5.5 m or
less is rounded down and backed up.
RS-232C hardware error
count
Counts when a parity error, overrun error, or framing error
occurs.
* When data of several bytes is transmitted continuously,
counting is performed per byte.
System error count Counts when a No.20 system error described in the
section, “5.20 LCD MESSAGES AND LED INDICATIONS”,
occurs.