Toshiba B-EP Series - Page 152

- 143 -
Values after parameter clear
Parameter Value
Feed amount fine adjustment (PC) +0.0mm
Print tone fine adjustment (PC) +0step
Strip position fine adjustment (PC) +0.0mm
Feed amount fine adjustment (Key) +0.0mm
Print tone fine adjustment (Key) +0step
Strip position fine adjustment (Key) +0.0mm
X-coordinate fine adjustment (Key) +0.0mm
Transmissive sensor manual threshold fine adjustment value 1.4V
Reflective sensor manual threshold fine adjustment value 1.0V
Print command language TPCL
Print type (BATCH/STRIP) AUTO
Post-print stop position setting CUT
Back feed restriction setting ON
Strip issue back feed setting OFF
Strip sensor sensitivity adjustment AUTO
Character code PC-850
Font zero “0” (without slash)
LCD language QM type ENGLISH
JA type JAPANESE
Control code AUTO
EURO font code B0H
Automatic print head check for broken dots OFF
MaxiCode specification TYPE1
Head division AUTO1
Print head check for broken dots after cover close OFF
Resume printing after broken dots error OFF
Feed to top of feed after cover close OFF
B-SP series compatibility mode OFF
Linerless OFF
XML OFF
Beep volume 1
Auto power-off timing 120 min.
Power save mode timing 3 sec.
LCD backlight off timing 3 sec.
BASIC interpreter setting
OFF
BASIC trace setting
OFF
Shell function
OFF
Label pitch B-EP2/203 dpi
63.0 mm
B-EP4/203 dpi
63.0 mm
Effective print length B-EP2/203 dpi
60.0 mm
B-EP4/203 dpi
60.0 mm
Effective print length B-EP2/203 dpi
48.0 mm
B-EP4/203 dpi 104.0 mm
Sensor Transmissive sensor
PC-save automatic call ON