Toshiba B-EP Series - Page 68

- 59 -
Item Description
Value
CODE
Control code AUTO: Automatic selection
ESC LF NUL: ESC LF NUL method
{ | }: { | } method
EURO CODE EURO font code
Any code
AUTO HD CHK
Automatic print head check for
broken dots
OFF: An automatic print head check
for broken dots is not
performed.
ON: An automatic print head check
for broken dots is performed.
MAXI CODE SPEC.
MaxiCode specification TYPE1: Compatible with existing
versions
TYPE2: Special specification
HEAD DIVISION Head division B-EP2 (2-inch) B-EP4 (4 inch)
AUTO1
AUTO2
DIV3
AUTO
AUTO1
DIV6
AUTO
HEAD ERR CHECK. Print head check for broken dots
after cover close
OFF: A print head check for broken
dots is not performed after the
cover is closed.
ON: A print head check for broken
dots is performed after the
cover is closed.
HEAD ERR PRINT Resume printing after broken dots
error
OFF: The printer does not resume
printing after a broken dots
error occurs.
ON: The printer resumes printing
after a broken dots error
occurs.
FEED CHECK Feed to top of feed after cover
close
OFF: No feed is performed after the
cover is closed.
ON: A feed is performed after the
cover is closed.
B-SP MODE B-SP series compatibility mode
OFF: B-SP series compatibility
mode is disabled.
ON: B-SP series compatibility
mode is enabled.
LINERLESS Linerless
OFF: Linerless setting is disabled.
ON: Linerless setting is enabled.
PAPER STOP
* Supported on V1.0E or later
Post-print stop position setting
CUT: Stop at the cut position
HEAD: Stop at the head position
BF.RESTRICT
* Supported on V1.0E or later
Back feed restriction setting
ON: Back feed restricted
OFF: No back feed restricted
PEEL BF.
* Supported on V1.0E or later
Strip issue back feed setting
OFF: Back feed allowed
ON: No back feed allowed
XML XML
OFF: XLM setting is disabled.
ON: XLM setting is enabled.
BEEP VOL Beep (buzzer) volume
OFF
1 to 3
AUTO POWER OFF Auto power-off timing
OFF
1 to 300 min.
SLEEP Power save mode timing
1 to 30 sec.
LCD LIGHT OFF LCD backlight off timing
OFF
1 to 30 sec.