Toshiba B-EX4 SERIES - Page 105

5. SYSTEM MODE EO18-33027
5.3 DIAG
5-9
<< PARAMETER SETTINGS >>
Item
Description
Printed value
MEDIA LOAD
Media loading
NOTE: Even if the “ECO+Bfeed” is
selected for the B-EX4T2, B-EX6T2,
or B-EX4D2, the setting and the
printer behavior will be automatically
changed to “ECO”.
OFF
Disabled
STD
Feeds the detected
gap/mark to print start
position.
ECO
Feeds gap/mark
between print head and
sensor to print start
position.
ECO+BFeed
Back feed follows ECO
printer behavior.
FORWARD WAIT
Forward feed standby after
issue
ON
Performed
(A fine adjustment value
for the stop position is
also printed.)
OFF
Not performed
FW/BK ACT.
Forward feed standby action
NOTE: Models supporting MODE3:
B-EX4T1-G/T-QM/CN C1.2 or later
B-EX4T1-TS25-R V2.1 or later
MODE1
Stops after 13.7-mm
forward feed.
MODE2
Stops after 6-mm back
feed and 3-mm forward
feed. (Only when the cut
mode, thermal transfer,
and feed gap sensor is
selected.) In other
cases, the printer stops
after 13.7-mm forward
feed.
MODE3
(Note)
Stops after 31.2-mm
forward feed. This is an
exclusive specification
for issuing RFID media.
HU CUT/RWD.
Head-up operation in cut
issue mode, or use of the
Rewinder
NOTE: Since head-up function is not
available to the B-EX4T2, B-EX6T2,
and B-EX4D2, this parameter is to
choose whether to use the Rewinder.
The head-up operation is fixed to
OFF.
ON
Head-up operation is
performed, or the
rewinder is used.
OFF
Head-up operation is not
performed, or the
rewinder is not used.
RBN SAVE
Use of ribbon saving
module
NOTE: Even if the “TAG” or LABEL”
is selected for the B-EX4T2, B-
EX6T2, or B-EX4D2, the setting and
the printer behavior will be
automatically changed to “OFF”.
ON:TAG
Used.
Head lever position:
“TAG”
ON:LABEL
Used.
Head lever position:
“LABEL”.
*Supported only by the B-EX4T1-
TS25-R V2.0 or later
The difference between “ON:TAG”
ON:TAG2 *
Used.
Head lever position:
“TAG”