Toshiba B-EX4 SERIES - Page 104

5. SYSTEM MODE EO18-33027
5.3 DIAG
5-8
(RBN WIDTH
TYPE2) *1
RBN(FW)
Ribbon motor drive voltage fine
adjustment (Take-up)
-15 to +10 step
RBN(BK)
Ribbon motor drive voltage fine
adjustment (Back tension)
-15 to +10 step
[KEY] FEED
Feed amount fine adjustment
-50.0mm to +50.0mm
CUT
Cut position (or strip position) fine
adjustment
-50.0mm to +50.0mm
BACK
Back feed fine adjustment
-9.9mm to +9.9mm
TONE (T)
Print density fine adjustment
(Thermal transfer print mode)
-20 to +10 step
TONE (D)
Print density fine adjustment
(Direct thermal print mode)
-20 to +10 step
RBN (FW) *1
Ribbon motor drive voltage fine
adjustment (Take-up)
-15 to +10 step
RBN (BK) *0
Ribbon motor drive voltage fine
adjustment (Back tension)
-15 to +10 step
(RBN WIDTH
TYPE1) *1
RBN(FW)
Ribbon motor drive voltage fine
adjustment (Take-up)
-15 to +10 step
RBN(BK)
Ribbon motor drive voltage fine
adjustment (Back tension)
-15 to +10 step
(RBN WIDTH
TYPE2) *1
RBN(FW)
Ribbon motor drive voltage fine
adjustment (Take-up)
-15 to +10 step
RBN(BK)
Ribbon motor drive voltage fine
adjustment (Back tension)
-15 to +10 step
X ADJ.
X-coordinate fine adjustment
-99.5mm to +99.5mm
THRESHOLD<R>
Threshold fine adjustment for
reflective sensor
0.0V to 4.0V
THRESHOLD<T>
Threshold fine adjustment for
transmissive sensor
0.0V to 4.0V
HD ADJ.
Head down timing fine adjustment
* Supported from firmware version of
V2.0B for the B-EX4T1-TS25-R.
-30msec. to +30msec.
*1: The ribbon motor drive voltage fine adjustment parameters are different depending on the model.
Model
Parameter
B-EX4T1-G/T-QM/CN C1.2 or later
B-EX4T2-G/T-QM/CN C1.2 or later
B-EX4T2-H-QM/CN C1.1A or later
B-EX4D2-G/T-QM/CN D1.1 or later
(RIBBON WIDTH
TYPE1)
RBN(FW)
RBN(BK)
(RIBBON WIDTH
TYPE2)
RBN(FW)
RBN(BK)
Other than above
RBN(FW)
RBN(BK)
NOTE: This parameter is not used for the B-EX4D2-G/T.