Toshiba B-EX4 SERIES - Page 103

5. SYSTEM MODE EO18-33027
5.3 DIAG
5-7
FEED1 to FEED4
History of label distances covered
0.0 to 3200.0 km
History of the last 4 label distances.
PRINT
Print distance
0.0 to 200.0 km
Counted while printing. (Reverse feed is not counted.)
B-EX4T1-G/B-EX4T2-G/B-EX6T2-G/B-EX4D2-G:
When the power is turned off, the print distance of 8.2 m or less is rounded down when backed up.
B-EX4T1-T/B-EX4T2-T/B-EX6T2-T/B-EX4D2-T:
When the power is turned off, the print distance of 5.6 m or less is rounded down when backed up.
B-EX4T2-H:
When the power is turned off, the print distance of 2.8 m or less is rounded down when backed up.
PRINT1 to PRINT4
History of print distances
0.0 to 3200.0 km
History of the last 4 print distances.
CUT
Cut count
0 to 1000000
Every cut operation is counted.
The cut count is saved every 4 cut operation.
HEAD U/D
Head up/down count
0 to 2000000
The number of times the print head moves up and down with the solenoid for ribbon save is counted. (A set of
up and down is counted as one.)
The head up/down count is saved every 4 head up/down operation.
RIBBON
Ribbon motor drive time
0 to 2000 hours
Note: The counter value for the B-EX4D2 is indefinite.
Counted when the ribbon motor is driven while paper feed or printing. (Reverse feed is also counted.)
When the power is turned off, drive time of 10 seconds or less is rounded down when backed up.
SOLENOID
Head-up solenoid drive time
0 to 1000 hours
Counted when the ribbon saving operation is performed.
When the power is turned off, drive time of 10 seconds or less is rounded down when backed up.
232C ERR
RS-232C hardware error count
0 to 255
Counted when a parity error, overrun error or framing error occurs.
SYSTEM ERR
System error count
0 to 15
Counted when a system error occurs.
POWER FAIL
Momentary power interruption count
0 to 15
Counted when a momentary power interruption occurs.
<< ADJUST >>
Item
Description
Remarks
[PC] FEED
Feed amount fine adjustment
-50.0mm to +50.0mm
CUT
Cut position (or strip position) fine
adjustment
-50.0mm to +50.0mm
BACK
Back feed fine adjustment
-9.9mm to +9.9mm
TONE (T)
Print density fine adjustment
(Thermal transfer print mode)
-10 to +10 step
TONE (D)
Print density fine adjustment
(Direct thermal print mode)
-10 to +10 step
RBN (FW) *1
Ribbon motor drive voltage fine
adjustment (Take-up)
-15 to +10 step
RBN (BK) *1
Ribbon motor drive voltage fine
adjustment (Back tension)
-15 to +10 step
(RBN WIDTH
TYPE1) *1
RBN(FW)
Ribbon motor drive voltage fine
adjustment (Take-up)
-15 to +10 step
RBN(BK)
Ribbon motor drive voltage fine
adjustment (Back tension)
-15 to +10 step